1.installation Angle: the Angle can be installed on the top of the roof or balcony metope, corner top 50-70 cm distance activity, must be in the middle of the activities of the roof into triangle (45 degree Angle), and the installation of wave position to maintain the same vertical line, you can see the drawings.
Four, wire connection: a set of dryer There are two wire, took out a root, first to the end of the first turn on the wire through the Angle of bearing steel wire slot, and then through the activities of the end cap wheel bearing steel wire slot (located at the top of the upper), and then through the fixed end of the top bearing steel wire slot for wire perpendicular to the ground, and then from wire set into the lid, card good top cover. The other side of the steel wire is through the Angle of bearing steel wire slot another hole, and then through the activities of another activity wheels bearing steel wire slot (the same below), let the steel wire is perpendicular to the ground, and then from wire set into the lid, card good top cover. Another wire installation method is the same.
2.air connections: in each the head end of the wire, wear lob, the knot in the lob; Then pull the lob to resist the top so far, out of the corner steel wire at this moment, just as a twin wire, one end of the card at hand; Relax in the hand is steel wire, the drop drop, the hanging rod through the lob, then tighten fixed on the lob holes, screw good screw; The last plug on the ends of the hanging rod installation.